If it’s not obvious from the title, this is a basic code walkthrough for the Python code that runs my Raspberry Pi Display Sign. This was my first time ever writing Python, so I don’t claim to have done it the best, or even correct, way but the code does work. The code is available on my GitHub, so feel free to grab it to use, modify or laugh at 🙂
Tools List:
(purchasing via these affiliate links supports ILTMS)
- SawStop cabinet saw
- Dewalt 20v drill driver combo
- Dewalt compound miter saw
- Orbital Sander
- Pancake compressor/nail gun combo
- Grizzly 14″ Bandsaw
- Grizzly Drill Press (WAAAAY overpriced (3x) on Amazon, buy from Grizzly directly.)
- Shop Fox Hanging Air Filter
- 2HP Dust Collector
- 1 Micron bag
- Classic steel ruler (cork backed)
- 90˚ corner clamp (4 pack)
- Silhouette Portrait (vinyl cutter)
- Raspberry Pi 3
- 32×32 LED matrix
- RGB Matrix Pi Hat
- 5v 4 amp power supply
- Arcade buttons
- Momentary button (for on/off)
- Wire
- jumpers (Male to Female)
- Soldering iron
- Third hand kit
- Wire strippers (not the ones I have, but good ones)
- Thin solder
- Anti static mat
- Fiskars cutting mat
